Car Memory Data Saver Automotive Emergency Power Supply Cable Battery Cable OBD II Memory Saver Connector

Two LEDs on the Car Data Saver Lights Green

If both the two LEDs on the Car Data Saver lights green, the charge level of this storage battery is high enough.

If a LED on the Car Data Saver lights green and another LED lights red, this storage battery is not high enough

and needs to be charged before it can be used as a temporary power source, or you can use another 12V storage

battery which is high enough as atemporary power source.

Connecting the Car Data Saver to the OBD-II port

Warning: To avoid overload of this Car Data Saver, turn off all accessories and all electrical appliances of

the car ( such as radio, audio device, lights ) before using this Car Data Saver;

otherwise this Car Data Saver may be damaged.

Connecting the Car Data Saver to the Cigarette Lighter Socket

NOTE

• If a LED on the Car Data Saver gives abnormal indication, stop using the Car Data Saver and disconnect its connections with the car and the storage battery which is used as a temporary power source. Then check whether the Car Data Saver is damaged and whether the Car Data Saver's connections were correct.

• Don't short the red clip and the black clip of the Car Data Saver.

• Never short the positive terminal and the negative terminal of any battery.

• Always adhere to the relevant instructions of the car's users manual and service manual when you make any connection or disconnection.

• The Car Data Saver can only be used on 12V car electrical system.

• Do not operate the Car Data Saver where explosive gas, vapor, or dust is present.

• Use storage battery only in well-ventilated area.

• The Car Data Saver's operation temperature is: 0°C to 40°C; and storage temperature is: -10°C to 50°C.