Vgate iCar 1 WIFI/Bluetooth OBD2 Code Reader

The Vgate iCar 1 WIFI/Bluetooth Version OBD2 Code Reader supports all OBDII protocols and is compatible with Android, iOS, and Windows devices.

VGATE WIFI OBD Multiscan ICAR ELM327 Car Diagnostic Adapter

This adapter supports all OBD-II self-diagnostic systems and automatically detects compatible communication protocols. Key functions include:

• Read general and automobile manufacturer-specific diagnostic fault codes and display their definitions (software includes over 3000 fault codes)
• Clear fault codes and turn off the engine fault alarm indicator (MIL/"Check Engine" light)
• Read real-time engine data parameters such as:
  • Engine speed (RPM)
  • Calculated load value
  • Coolant temperature
  • Fuel system status
  • Vehicle speed
  • Short-term and long-term fuel correction
  • Intake manifold pressure
  • Timing advance
  • Intake air temperature
  • Air flow rate
  • Throttle valve opening
  • Oxygen sensor voltage and short-term fuel fine-tuning
  • Fuel pressure

Top 11 Reasons to Get VGATE Wifi ELM327

1. Software Version: V2.1
   Hardware Version: V2.1
2. Supports Android, PC, iPhone, and iPad
3. Fully compatible with ELM327 V1.4b
4. All ELM327-supported software can be used
5. Up to four times faster than standard ELM327 (uses ARM 16-bit MCU vs. RISC 8-bit 44MHz MCU)
6. Built-in power switch
7. Low standby power consumption with sleep mode
8. Lower overall power consumption than ELM327
9. Front-facing LED indicators for easy status monitoring
10. Supports J1939 protocol beyond standard ELM327 capabilities
11. WiFi 802.11 b/g with WEP128 encryption for enhanced security

Supported OBDII / EOBD Protocols

• SAE J1850 PWM (41.6 Kbaud)
• SAE J1850 VPW (10.4 Kbaud)
• ISO9141-2 (5 baud init, 10.4 Kbaud)
• ISO14230-4 KWP (5 baud init, 10.4 Kbaud)
• ISO14230-4 KWP (fast init, 10.4 Kbaud)
• ISO15765-4 CAN (11-bit ID, 500 Kbaud)
• ISO15765-4 CAN (29-bit ID, 500 Kbaud)
• ISO15765-4 CAN (11-bit ID, 250 Kbaud)
• ISO15765-4 CAN (29-bit ID, 250 Kbaud)
• SAE J1939 CAN (29-bit ID, 250* Kbaud)
• USER1 CAN (11*bit ID, 125* Kbaud)
• USER2 CAN (11*bit ID, 50* Kbaud)

Functions

• Read more than 3000 standard and manufacturer-specific Diagnostic Trouble Codes (DTCs) with definitions
• Clear DTCs and turn off the dashboard MIL ("Check Engine") light
• Display real-time sensor data including:
  • Engine RPM
  • Load
  • Coolant Temperature
  • Fuel Status
  • Vehicle Speed
  • Intake Manifold Pressure (MAF / MAP)
  • Timing Advance
  • Intake Air Temperature
  • Air Flow Rate
  • Absolute Throttle Position
  • Oxygen Sensor Voltage / Short Term Fuel Trim
  • Fuel Pressure

Product Specifications

• OBDII Decode Chip: ARM 16-bit MCU
• Firmware: ELM327 Version 1.4b compatible
• Transfer Baud Rate: 4800 / 9600 / 10400 / 38400 / 500K
• Input Interface: OBDII male 16-pin
• Output Interface: WiFi 802.11 b/g
• LED Indicator: Power (red) / OBD (green) / Link (blue) for PC or smartphone
• Operating Voltage: 12V with over-voltage and short-circuit protection
• Nominal Idle Current: 45mA
• Net Weight: 31g
• Gross Weight: 60g
• Wire Length: 0 cm
• SSID: BUYOBD
• Password: See item label
• IP Address: 192.168.0.10
• HTTP Local Port: 35000
• Encryption: WEP128
• Power Source: Supplied by car OBD socket

OBDII 16-Pin DLC Definition

• 1. n/a
• 2. Bus + (SAE J1850 PWM, VPW)
• 3. n/a
• 4. Battery –
• 5. Signal –
• 6. CAN High (ISO 15765-4)
• 7. K Line (ISO 9141-2, SAE J2234)
• 8. n/a
• 9. n/a
• 10. Bus – (SAE J1850 PWM, VPW)
• 11. n/a
• 12. n/a
• 13. n/a
• 14. CAN Low (ISO 15765-4)
• 15. L Line (ISO 9141-2, ISO 14230-4)
• 16. Battery +

Only pins 2, 4, 5, 6, 7, 10, 14, 15, and 16 are defined by the above standards for data reading. Other customized pins are not supported. Please confirm the OBDII label located under the front engine hood.

Package List

• 1pc x Vgate iCar 1 (WIFI Version)
• 1pc x User's Manual
• 1pc x Color Box