New C5 OBD2+GPS Head Up Display Head Up Display Speedometer HUD Car Windscreen Speed Projector KMH/KPM Compatiable With all Cars
New C5 OBD2+GPS Head Up Display Head Up Display Speedometer HUD Car Windscreen Speed Projector KMH/KPM Compatiable With all Cars
UKOBD2 Provide top quality New C5 OBD2+GPS Head Up Display Head Up Display Speedometer HUD Car Windscreen Speed Projector KMH/KPM Compatiable With all Cars, if you need New C5 OBD2+GPS Head Up Display Head Up Display Speedometer HUD Car Windscreen Speed Projector KMH/KPM Compatiable With all Cars, or have any questions about New C5 OBD2+GPS Head Up Display Head Up Display Speedometer HUD Car Windscreen Speed Projector KMH/KPM Compatiable With all Cars, welcome to contact us.
Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Porsche Piwis III, USB Link 2, Scania VCI3, CAN Clip, wiTech MicroPod 2, T300 key programmer, locksmith tools
images of New C5 OBD2+GPS Head Up Display Head Up Display Speedometer HUD Car Windscreen Speed Projector KMH/KPM Compatiable With all Cars
Product function:
1.Compass: Show the driving direction when the vehicle speed >5KM / H
2.Light sensor: HUD can automatically adjust the brightness according to the environment
3.Lane display:standard version does not support this function
4.Fault code icon,connection icon(No function),OBD system,GPS system (GPS icon will flashing untilsatellite signal been founded)
5.Camera monitoring area (standard version does not support this function)
6.Multi-function area: RPM,water temperature,voltage,fuel consumption,altitude,mileage,
driving time,power test,satellites number,clock
7.RPM=rotating speed,°C/F=water temperature,V=voltage,LHK=fuel consumption,ASL=altitude,
TRIP=travel mileage,D=standard version no function,MIN=travel time,a +=100km acceleration test,GPS=satellites number(GPS system can be used after 5 satellites are found)
8.Vehicle speed display
9.Speed unit: MPH=Mile/hour, KM/H=kilometer/hour
10.RPM icon
System selection
Please short press ‘<’ button to switch the mode OBD or GPS when the OBD icon flashes, it will automatically enter the last selected system after 5 seconds of inactivity.
OBD System(For OBD2 car)
Functions:Vehicle speed,engine RPM,fuel consumption,water temperature,voltage,clock,mileage,
travel time,travel distance,altitude,number of compass satellites, RPM icon
GPS System(For all car)
Functions:Vehicle speed,time,voltage,travel time,travel distance,travel direction,altitude,satellites number,speed Icon
Floating imaging。Large screen,viewing angle
1.wide viewing angle 2.HD without ghosting 3.Multifunctional display
4.stereo imaging 5.No need to stick film 6.come with hood
Built-in display film, no need to paste film, no ghosting, use translucent emission lens to suspend the information three-dimensional display in the air
No matter the placement, it is clear and natural, in line with the driving sight
speed. Clock, RPM, water temperature, voltage, fuel consumption.Altitude, mileage, driving time. Power test, number of satellites
Master-level design, unique ingenuity, every inch is carefully manufactured, Using seamless fastening technology to make the shape of C5 more perfect
Super wide screen, adjustable to your comfortable driving angle
A variety of interfaces can be switched at will to meet different needs and make driving more convenient
Dual mode, OBD data + GPS data can be displayed at the same time, GPS data is suitable for all models
Use 10 Hz high refresh GPS + Beidou dual-mode chip The refresh rate is 10 frames per second, and the vehicle speedis refreshed quickly without delay
Introduce the core algorithm of Taiwan technology and add the speed calibration function, which can be adjusted to beconsistent with the car dashboard display
Set different parameter over-limit alarms, icon flashing alarms, sound alarms to improve driving safety
One key to clear the fault code, solve the problem in time, without additional time and cost
Hundred-kilometer acceleration refers to O to 100km/h acceleration time, which is the most intuitive manifestation of automobile power
Equipped with photosensitive elements, adjust the brightness of the display according to the intensity of the light, all-weather, all-environment, clear display, no glare when driving
With the car start and stop, automatic switch and shutdown
1.OBD line power supply
2.Cigarette lighter cord power supply
1.C5-head-up display x1
2.Cigarette lighter cord x1
3.OBD line x1
4.cleaning cloth x1
5.Manual x1
1.No function is displayed,no power
Check whether the OBD cableis tight connection,pull down repeatedly to confirm,please try it on another car if still not workable,analysis if it is an error from OBD diagnostic interface,if yes,please repair it and connect the device again.
2.Only the car voltage displays and be automatic power off after 30 second
(1) This product is only available for OBDII and EOBD cars when it is in OBD2 mode
(2) This product OBD2 mode does not support OBD I and JOBD
(3) OBD2 is a car protocol(U.S.A Cars:2003 Other regions:2007)
(4) Switch to the GPS system using the USB cable to display, within 5 seconds of power Pull right the button to select the GPS system.
3.The vehicle speed on HUD is not as same as speedometer’s
(1) Please check that the unit is correct KM/mile MPH, (speed unit switch please refer to the settings)
(2) Vertical long press into the system settings, pull right the button to select the speed adjustment menu,and make a fine-tuning (e.g. meter displays 100 Km/h,device shows 105Km/h,use default value 107-5=102 ).
4. There is an error on fuel consumption
(1) Checking your car displacement and make sure that the engine displacement of the device is as same as your car’s(e.g. car is 2.0L,please set parameter value to 2.0L)
(2) if the displacement is the same,you can also do a fine-tuning settings(e.g. equipment fuel is higher than 0.2L,please set the parameter to 98%) Recommended: fine-tuning is optional since it is a real data from car computer
5.The device cannot auto power off
Adjust the sleep voltage to 13.2V or 13.6V, then HUD will power off in 3 minutes.
6.Auto start- stop cars
Adjust the shutdown voltage setting in the system settings to the COM mode
7. Automatic start-up will auto off when step the brake and same situation on Hybrid car in the traffic.
(1) Setting to COM mode(in the menu of shutdown voltage)
(2) Setting shutdown delay to 300 seconds,so that it can turn off after 5 minutes
(3) Please switch to the GPS system(Dial up the scroll wheel within 5s)
8.Wrong operation lead to crashes
(1)Does the OBD2 interface use other OBD equipment (position, tire pressure monitoring, drop lock, lift window folding, ELM27)
(2)Modified and retrofitted (central control navigation electronic throttle accelerator fixed speed cruise brushed computer system
(3)One-key start, keyless entry, remote start) will cause crashes, unplug other OBD devices and use the product directly, to restore factory settings (see the setting table for details)
(4)Press and hold the scroll wheel to enter the setup menu, right-click the scroll wheel to switch to system settings, press the scroll wheel vertically to enter the system settings, right-click the scroll wheel to switch to factory settings, and press the scroll wheel vertically to confirm.
(5)If you haven't solved it, please switch to GPS system and use USB cable for display. Turn on the power and turn the dial for 5 seconds to select the GPS system.
GPS FAQ;
1.The screen without any display,and no power
Start the car engine;check if the cable line is tight;or connect the USB to the computer to check
2.Without car Speed
After HUD power-on, the GPS will start to find the satellite. Please drive the car to the road. It will work once gets more than 5 satellite signals.
3. Cannot be turned on automatically or repeatedly extinguished during driving
Please use the USB cable to insert the cigarette lighter
If you use the OBD cable, change the sleep voltage to 13.0V or 12.8V
If use the USB cable, make the sleep voltage off.
4.Inaccurate time
Enter the setting items: system time adjustment, turn the dial to the right to adjust the time zone time, after adjusting, press the dial vertically shortly for 2 seconds to save and exit
5.Speed is not correct
(1) If the unit is correct,km KM/mile MPH, (speed unit switch reference settings item)
(2) The car factory had increased speed(5-7%)than real for drivers’ safety,satellite data is strictly follow the international standards
(3) Fine-tuning the vehicle speed, e.g. meter display 100 Km/h, machine display 105Km/h,default value 107-5=102
6.Driving direction display error
After the vehicle speed exceeds 5KM/H, the direction can be displayed normally.
7.Speed is still on display after the car stops
Satellite drift will be caused in underground parking,tunnel,overpass or blockers,please drive your car on open road,then this situation can be solved after the satellite numbers >5
8.HUD cannot be automatically shut down after car stopped
(1) HUD can be shut down in 3 minutes(in OBD mode)
(2) If not in 5 minutes,set item shutdown voltage to 13.5V or use the USB cable