bmw ews32 emulator

BMW EWS2 EWS3.2 emulator, it is an emulator for BMW E34 E36 E38 E39 E46.

Emulator E34 E36 E38 E39 E46 for BMW EWS2 EWS3.2 Best Selling Free Shipping is a one of our bmw ews32 emulator Tools, you can buy Emulator E34 E36 E38 E39 E46 for BMW EWS2 EWS3.2 Best Selling Free Shipping from ukobd2.com.

Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Handy Baby II Car Key Chip Copier, CDP DS150

images of Emulator E34 E36 E38 E39 E46 for BMW EWS2 EWS3.2 Best Selling Free Shipping

Emulator E34 E36 E38 E39 E46 for BMW EWS2 EWS3.2 Best Selling Free ShippingEmulator E34 E36 E38 E39 E46 for BMW EWS2 EWS3.2 Best Selling Free ShippingEmulator E34 E36 E38 E39 E46 for BMW EWS2 EWS3.2 Best Selling Free Shipping


Emulator E34 E36 E38 E39 E46 for BMW EWS2 EWS3.2
Top 2 Reasons To Get BMW EWS2 EWS3.2 Emulator
1. There are NO any counters or car starts limited. You can change and store new ISN without any limitations.
2. Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by default.

Notice: In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to diagnostic K-line.

Connection Picture:

bmw-ews2-ews32-emulator-e34-e36-e38-e39-e46-2394-connection


BMW EWS Emulator Installation:

1. Remove original EWS2 control unit, find +12v ACC, GND, K-line wires, attach emulator. Emulator must be in service mode: JUMPER 1 shorted.
2. Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch EMULATOR
CONFIGURATION UTILITY:

bmw-ews-emulator-installation
3. Choose COM port, write in desired ISN number, press button Store. Or -
4. For some ECU s it is possible to read ISN number directly from engine control unit. In this case
select Option ECU xxxxx , press Read. Software will try to read ISN. If successful, choose option
EWS emulator and press button Store to save ISN number into emulator.
5. Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to
DME(DDE) <-> EWS line.
6. Don t forget to short two starter relay wires (EWS connector)!
7. Car is ready to start.

In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to
diagnostic K-line.
There are NO any counters or car starts limited. You can change and store new ISN without any limitations.
Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by default.

Package including:

1pc x BMW EWS2 EWS3.2 Emulator E34 E36 E38 E39 E46


Go to Buy: Emulator E34 E36 E38 E39 E46 for BMW EWS2 EWS3.2 Best Selling Free Shipping

LONSDOR Key Programmer Porsche Piwis III GM Tech2 USB Link 2 CAN Clip wiTech MicroPod 2 T300 key programmer locksmith tools a b c d e f g h i j k l m n o p q r s t u v w x y z
Share to Pinterest