New Arrival VVDI RKE BOX Remote Control Switching Box Supports 6V/9V/12V
Xhorse VVDI RKE BOX is applied at the following aspects:1. To change the original straight remote control to folding remote2. No method or apparatus temporarily to add a new remote control3. Temporary replacement because of the original out of stock4. Only one remote for the original car (such as the Chinese, Besturn, etc.)5. To seek low-cost remote control instead of the expensive original one
UKOBD2 Provide top quality New Arrival VVDI RKE BOX Remote Control Switching Box Supports 6V/9V/12V, if you need New Arrival VVDI RKE BOX Remote Control Switching Box Supports 6V/9V/12V, or have any questions about New Arrival VVDI RKE BOX Remote Control Switching Box Supports 6V/9V/12V, welcome to contact us.
Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Porsche Piwis III, USB Link 2, Scania VCI3, CAN Clip, wiTech MicroPod 2, T300 key programmer, locksmith tools
images of New Arrival VVDI RKE BOX Remote Control Switching Box Supports 6V/9V/12V
VVDI RKE BOX Remote Control Switching Box Support 6V/9V/12V
1. Power Options
By default, the device connects to a 3V remote control with no welded joints required.
To connect a 6V, 9V, or 12V remote control, disassemble the main box and select the corresponding welded joints as shown in the image below.
Example: For a 6V remote control, only the 6V welded joints should be connected.
2. Wiring Description
Remove the circuit boards from the original remote control and connect them to the main unit as illustrated in the image on the right: white wire to buttons, red wire to positive, and black wire to negative.
Remote Button Types
The system supports three types of remote buttons:
- 2-feet buttons: No direction distinction; solder each foot separately.
- 4-feet and 5-feet buttons: No direction distinction; must be soldered at diagonal points.
Labels in the wiring diagram:
- Original remote control
- Positive
- Negative
- Remote wiring diagram
IMPORTANT: Do not reverse the power cord on the remote control.
3. Power Supply Options
Power can be supplied via OBD or 12V constant power from the car.
4. Key/Remote Matching and Clearing
Matching Steps
- Press the SET button on the host box (located in the internal hole on the side of the unit). The buzzer will beep twice, indicating entry into matching mode.
- Press and hold any button on the new remote until the buzzer beeps continuously. Key matching is now complete.
- Repeat these steps to add additional remotes.
Matching Notes
- A maximum of six keys can be matched to one host box. Matching will fail if more than six are attempted.
- If no key is detected within 10 seconds during matching mode, the buzzer will beep once and the unit will automatically exit matching mode and return to normal operation.
Clearing Steps
Press and hold the SET button until the buzzer beeps continuously. This clears all previously matched keys and restores the unit to factory settings.
Clearing Note
If a key is lost or no longer needed, erase all keys and re-add only the required ones to maintain security.
Diagram labels:
- Buzzer
- Key to be added
- SET button
5. Adding Key Embryo and Anti-Theft Chip
Instructions for integrating a key embryo and anti-theft chip into the remote control are supported by the system.
Package Includes
- 1pc × VVDI RKE BOX
- 2pc × key
Go to Buy: New Arrival VVDI RKE BOX Remote Control Switching Box Supports 6V/9V/12V