New 468 Key Pro III Third Generation ID46 Copy Key Programmer
468 Key Pro III is a key programmer, you can insert the key directly to this device to copy ID46 chips. It help you read and write 46 chips information easily.
UKOBD2 Provide top quality New 468 Key Pro III Third Generation ID46 Copy Key Programmer, if you need New 468 Key Pro III Third Generation ID46 Copy Key Programmer, or have any questions about New 468 Key Pro III Third Generation ID46 Copy Key Programmer, welcome to contact us.
Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Porsche Piwis III, USB Link 2, Scania VCI3, CAN Clip, wiTech MicroPod 2, T300 key programmer, locksmith tools
images of New 468 Key Pro III Third Generation ID46 Copy Key Programmer
468 Key Pro Third Generation ID46 Copy Key Programmer
Support Language: English
Attention: It can't support copy ID48 and 4D chips.
How to operate 468 Key Pro III?
1. Turn on the Left switch of 468 KEY PRO third generation, after turn on it, the main interface pops up. Then click COPY. copy46
2. Click CMT46 collect Upper left corner of the screen.
3. This page is a copy of the ID46-chip page, now it is copying ID46 chip.
3.1.Put the original chip vertically into the bottom right corner of the hole, click on read UID. Note: Do not going to be flat on the hole nearby, this is not easy to read information inside the chip.
3.2.Put the new key vertically into the bottom right corner of the hole, click on Conf ig. Note: Do not going to be flat on the hole nearby, this is not easy to read information inside the chip.
3.3.Use new car key collect information in car,first of all,take a key blank, put the new key into the key blank, insert the car key hole, four consecutive starts,each time interval of 3-5 seconds
6. If in the process, chip key copy failed, put the key into bottom right corner of the hole, click on Initialize, restart again from the first step.
Go to Buy: New 468 Key Pro III Third Generation ID46 Copy Key Programmer