VVDI RKE BOX wiring guide
Xhorse VVDI RKE BOX is applied at the following aspects:1. To change the original straight remote control to folding remote2. No method or apparatus temporarily to add a new remote control3. Temporary replacement because of the original out of stock4. Only one remote for the original car (such as the Chinese, Besturn, etc.)5. To seek low-cost remote control instead of the expensive original oneNote: at least one original remote control for use of the kit
VVDI RKE BOX Remote Control Switching Box Supports 3V is a one of our VVDI RKE BOX wiring guide Tools, you can buy VVDI RKE BOX Remote Control Switching Box Supports 3V from ukobd2.com.
Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Handy Baby II Car Key Chip Copier, CDP DS150
images of VVDI RKE BOX Remote Control Switching Box Supports 3V
VVDI RKE BOX Remote Control Switching Box Supports 3V
1. Wiring Description
Remove the circuit boards in the original remote control, and connect to the main unit as shown in the image below (connect the white wire to buttons, red to the positive terminal, black to the negative terminal).
Note: There are 3 types of remote buttons: 2-feet, 4-feet, and 5-feet buttons.
- 4-feet and 5-feet buttons: No direction distinction, but must be soldered at the diagonals.
- 2-feet buttons: No direction distinction; solder each of the two feet separately.
Labeled components referenced in wiring diagram:
- Original remote control
- Positive
- Negative
- Remote wiring diagram
IMPORTANT: Do not reverse the power cord on the remote control.
2. Power Supply Options
To get power via OBD or 12V constant power from the car.
3. Key/Remote Matching and Clearing
Matching Steps
- Press the SET button on the Host box (located in the internal hole on the side of the unit). The buzzer will beep twice, indicating entry into matching state.
- Press any button on the new remote for a few seconds until the buzzer beeps continuously. Key matching is now complete.
- Repeat the above two steps to add another new key.
Note:
- Up to six keys can be matched to one Host box; matching will fail if more than six are attempted.
- If no key is detected within 10 seconds during the matching state, the buzzer will beep once and automatically exit matching mode, returning to normal operation.
Clearing Steps
- Press and hold the SET button until the buzzer beeps continuously. All previously matched keys will be cleared, returning the unit to its factory state.
Note: If a key is lost or no longer in use, you can erase all keys and then re-add only the required ones to ensure security.
Referenced components:
- Buzzer
- Key to be added
- SET button
4. Adding Key Embryo and Anti-Theft Chip to the Remote Control
Package Includes
- 1pc × VVDI RKE BOX
- 2pc × key
Go to Buy: VVDI RKE BOX Remote Control Switching Box Supports 3V