AUTOOL CT60 Auto Fuel Injector Tester Fuel Injector Flush Tester Automotive Goods CT150 CT200 12V Pulse Pressure Boost Tester is a one of our AUTOOL CT60 Auto Fuel Injector Tester Tools, you can buy AUTOOL CT60 Auto Fuel Injector Tester Fuel Injector Flush Tester Automotive Goods CT150 CT200 12V Pulse Pressure Boost Tester from ukobd2.com.
Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Handy Baby II Car Key Chip Copier, CDP DS150
AUTOOL CT60 Auto Fuel Injector Tester, Fuel Injector Flush Tester Automotive Goods CT150 CT200 12V Pulse Pressure Boost Tester
AUTOOL CT60 is used to test car injectors to determine if the fuel injectors are stuck, leaking or burning. Multiple pulse outputs can be configured and speed, pulse width, run time, and other parameters can be adjusted as required. It is also possible to connect two nozzles for simultaneous operation to compare the spray status and spray angle of the fuel injector.
1 、Easily fix common faults like stuck, blocked, leaked or improper fuel injector combustion.
2 、Three-year warranty and lifetime maintenance.
3 、The pulse width and RPM can be adjusted continuously, and different programs can be applied to drive the injectors.
4 、During the cleaning process, pulse cleaning can be achieved by adjusting the RPM and width to optimize the cleaning effect.
5 、Can be used with any fuel pressure tester.
6 、This device can also be used with old ultrasonic cleaners and fuel injector testers. The GDI engine injector drive mode added to this machine can be used as an upgrade kit for the old version of the machine (machine without GDI unit).
1 、Turn off the vehicle's engine and remove the fuel injectors from the engine.
2 、Connect the pulse output to the fuel injector power input port.
3 、Connect the positive and negative electrode clamps to the 12V battery.
4 、Press the RPM "+" - "key to select the required analog speed. Press the" Start "button and the device starts working.
5 、Select the required injector.
6 、Place the device on the connecting kit, and then press the carburetor cleaner.
7 、Press RPM "+" and "-" keys, the tester will pulse the injector and then the pulse signal indicator will light. The device will start working.
8 、 Use self-pressure detergent, you need to select the corresponding connector and connect it well. Press the start button to start spraying and see the spray status and spray angle at a glance.
1 、Make sure the car engine must be turned off before using this device.
2 、Do not smoke or light near the car.
3 、Do not spill the car fuel on hot engine parts.
4 、Please perform this device in a well-ventilated place only.
5 、Do not go near any rotating part of the car, and do not touch any heating part of the car.
6 、Do not touch any car part with dangerous voltage logo.
7 、 wear qualified glasses.
① DP15 connector
②Fuel injector type indicator
③Display area
④RPM "+"
⑤TIME "-"
⑥Select button
⑦RPM "-"
⑧Working status indicator
⑨TIME "+"
⑩Pause
1pc* AUTOOL CT60 Automotive Injector Tester main unit
1pc* Power supply adapter
1pc* User manual
1pc* Injector connector
1pc* Connection line
1pc* Power supply cable